Page 410 - Irrigation Catalogue 2022 Bevo International

JOINING PVC FITTINGS TO SUITABLE RIGID & FLEXIBLE PVC PIPES
Before starting ensure fittings and pipe are of compatible size and standard. Ensure glue and cleaner are within 12 months of manufacture, are used within the temperature range noted on the tin and are compatible with each other.
1. PREPARATION
• Measure the required length of pipe and mark this with a permanent marker.
• Saw off the pipe at a right angle to the correct length with a PVC saw or cable saw for places
that are difficult to reach.
• Chamfer the end of the pipe (α =15) with a chamfering tool. This is done to ensure a better
distribution of the cement, to prevent scrapping away the cement and to create a locating
edge for easier assembly.
• Deburr the inside of the end of the pipe. This ensures that the pipe end is smooth and whole.
• Measure the insertion depth and mark this (the bonding surface) on the tube. This is important
so that excess adhesive is not applied to the pipe, which can corrode the pipe and weaken the
joint.
• Mark the correct assembly position of the fitting. Once the joint is assembled with the glue it
should not be rotated or adjusted.
• Clean the inside of the fitting with suitable cleaner and lint-free cloth. Cleaning ensures a
dirt- and grease-free surface and also provides a chemical pretreatment (pre-soak) for a better
bonding.
• Let the parts dry properly to reduce the chance of condensation.
• Clean the outside of the pipe with suitable cleaner and lint-free cloth.
2. GLUEING
First apply the glue to the fitting using the special brush (mostly integrated in the cap). The brush which is most suitable for the pipe diameter should be used. Apply a thin layer in the fitting and a somewhat thicker layer to the pipe end. Do not use too much of the glue, but ensure all surfaces have some covering. It is important that the glued surfaces do not come into contact with anything except each other.
3. ASSEMBLING
• Assemble the joint immediately in a single flowing, even movement. Do not turn or adjust.
• When the correct amount of glue is used evenly, a small constant depth ring of glue is
visible on the outside of the pipe and fitting interface.
• Remove excess glue immediately with the cleaner cloth. Superfluous glue can corrode
the pipe and thus weaken it if not removed swiftly.
408 IRRIGATION CATALOGUE